Marble Cutting Machine Introduction
marble cutting machine is a cutting machine which can install diamond saw blade to cut stone, concrete block, ceramic tile and other non-metallic brittle materials. It is mainly used for cutting edge or chamfering of all kinds of stone, porcelain, terrazzo square brick, refractory and other non-metallic brittle materials and products.
Marble Cutting Machine Advantages
1. The head of the marble cutting machine can rotate at a certain Angle to the working table to realize bevel cutting or bevel cutting.
2. The table is sent by hand.
3. The marble cutting machine is an ideal equipment for stone cutting in construction, building materials and other industries, with novel structure, convenient use, smooth slit and perfect use
Technical Parameters of Marble Cutting Machine
Voltage: 380V
Motor power: 4KW
Sawing length: 800mm
Head lifting height: 270mm
Nose Angle: 0° -- 45°
Saw blade speed: 2480r/min
Saw blade diameter: 350mm -- 500mm
Weight: 200KG
Marble Cutting Machine is widely used in the ceramic tile processing industry, mainly for cutting and trimming ceramic tiles. However, there will always be some small troubles in the process of processing ceramic tiles, such as uneven ceramic tiles cut out during cutting, uneven size, tile shaking phenomenon in the process of processing. How to solve this problem? The following introduces the marble cutting machine processing ceramic tile common problems and solutions.
1. Uneven cutting
When the tile is cut unevenly, it is necessary to adjust the press wheel device. First, check whether the center of the tape is aligned with the label, and both sides are symmetrical and perpendicular to the surface of the container. The adjustment of the press wheel can be adjusted up and down. When processing ceramic tiles, the press wheel should be perpendicular to the symmetrical position on both sides of the file ruler.
2. Uneven size
marble cutting machine needs to adjust the scale when the processing size is uneven, that is, the central axis of the scale is tangent to the label paper, and the central axis of the scale is aligned at three points. Adjust the tangent line (0 distance) between the scale and the label paper, and then move the scale closer to 1mm~2mm. The gap between the two sides of the scale should be 0.8mm-1mm. If the gap between the scale and the scale is too large, it is easy to cause displacement and hypotenuse in the processing of ceramic tiles.
3. Tiles shake up and down during processing
marble cutting machine in the process of shaking, need to adjust the brick wheel, brick wheel and belt. First, when adjusting the brick wheel and belt of marble cutting machine, the cutting blade of the motor shall prevail. First adjust the feed wheel. When the tile is just pressed into the feed wheel, adjust the feed wheel so that the tile is in the middle of the groove of the wheel. At this point, it is necessary to observe whether there is a shift of the belt. Subject to the incoming brick wheel.
The CNC marble cutting machine of Baotao machinery can be introduced for different materials of ceramic tiles. At the same time, the advantage of breakthrough is that, for the deformation of ceramic tiles caused by external distortion (not straight), it can cut and repair edges, so as to achieve no differentiation of cutting.
